Features:

• Clevis mounting holes are for 5/8" bolts
• Mounting holes are slotted to permit installation without removing insulators .  Insulators are shown for illustration only and must be ordered separately.

Material:

• Hot Dip Galvanized

                                  J1300

Features:

• Clevis mounting holes are for 5/8-inch bolts. Mounting holes are slotted to permit installation without removing insulators.  Insulators are shown for illustration only and must be ordered separately
• The J1300 is designed to develop high strength on deadends or line pulls. It has a mounting slot for one 5/8-inch machine bolt and two staggered side holes for 1/2-inch lag screws.

Material:

• Hot Dip Galvanized

• The J250 has two sharp projections in the back to prevent it from twisting. The cotter bolt is held in position by means of the same type of tab that is used on the J252. Insulators shown for illustration only and must be ordered separately

                      

                                 J250                                                                       J1398 / J1399

• The J252 and J255 Secondary Pulley Brackets are designed for use both as stringing pulleys and as secondary clevises, making them especially useful for stringing and sagging conductors.
• The conductor is strung and sagged with the bracket in the pulley position where it cannot bind. The 908 slot in the base makes it possible to rotate the bracket into the clevis position before or after the conductor is tied to the spool.
• The J252 light-type has a metal tab which contains the insulator bolt. The cotter bolt of the J255 heavy duty-type threads into the bottom of the clevis, locking the special Twist-Lock head into a groove in the clevis top. Both features eliminate the cotter pin.
• Insulators shown for illustration only and must be ordered separately

Material:

• Hot Dip Galvanized

               

                           J252                                                                    J255

Features:

• The J93 Clevis is formed from stiff, hot rolled channel, making it much heavier and stronger than similar brackets made of pressed steel channel.
• The J93 clevis features raised projections near the bolt mounting slot which assist in capturing the bolt head to resist turning.
• The J093 Clevis has an 11/16" square hole for mounting with either a 5/8" carriage or machine bolt.
• Insulators shown for illustration only and must be ordered separately

Material:

• Hot Dip Galvanized

             

                                       J93                                                               J093